Prusa Mini+ Benchy

After receiving my new Prusa Mini+, I printed a Benchy in eSun PLA+. The print came out well.

Printed at 210C with a 60C bed, there was a small amount of stringing with the eSun PLA+. I hadn’t used this brand before, and the printer was on default PLA settings.

Compared to the Wanhao Duplicator i3 Plus I had previously, it was a better print. The new version was printed at 0.15mm compared to Wanhao’s 0.2mm layer height.

One thing noticeable on the Wanhao (yellow) print is there is some shrinkage of the first ten to twenty layers. This shrinkage is noticeable on the bow and stern of the model.

Overall., both prints turned out well. The smaller layer height helped the Prusa Mini+ print look better than the Wanhao’s version.